Jon-
It looks like the command you are using is the correct command. I found this
in the Manual which may or may not apply to you.
"The MODIFY TABLE command can end unsuccessfully if the table being loaded is
partially or entirely contained in new extents (data spaces where information
is stored) within VTAMLIB. Because VTAMLIB is opened once during VTAM
initialization, the table is not accessible until VTAM is halted, restarted,
and VTAMLIB is opened again."
Something to check anyway.
Cheryl
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf
Of Jon Bathmaker
Sent: Thursday, August 18, 2016 6:37 PM
To: [email protected]
Subject: LOAD VTAM Logmode Table
Hi,
I am a VTAM usedtobe (in 1995) trying to get VTAM to load a new logmode table,
EMSMODE, into its tiny little mind so that I can use a 62x160 screen. I have
been able to get it to load the table to my active session with the following
command:
F NET,TABLE,TYPE=MODETAB,OPTION=ASSOCIATE,NEWTAB=EMSMODE,ID=A03AT001,OLDTAB=*
but of course when I log off/on again the modetab is what it was before I
issued the command which won't work. I have also tried F
NET,TABLE,TYPE=MODETAB,OPTION=LOAD,NEWTAB=EMSMODE which came back OK but did
not have the desired effect.
Any help, comments, witty sayings will be much appreciated. Thanks
Regards.
Jon Bathmaker
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions, send email to
[email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
