Hi Elardus,
We are using NVAS. I agree that EMSMODE is an NVAS logmode table.
No IEV043* messages.
I shall get the ops to bounce the Development LPAR on the W/E.
Best regards,
Jon Bathmaker
On 8/19/2016 8:37 AM, Elardus Engelbrecht wrote:
Jon Bathmaker wrote:
I am a VTAM usedtobe (in 1995) trying to get VTAM to load a new logmode table,
EMSMODE, into its tiny little mind so that I can use a 62x160 screen. I have
been able to get it to load the table to my active session with the following
command:
F NET,TABLE,TYPE=MODETAB,OPTION=ASSOCIATE,NEWTAB=EMSMODE,ID=A03AT001,OLDTAB=*
but of course when I log off/on again the modetab is what it was before I
issued the command which won't work. I have also tried F
NET,TABLE,TYPE=MODETAB,OPTION=LOAD,NEWTAB=EMSMODE which came back OK but did
not have the
desired effect.
NET is dynamic enough that you can do a F NET,blah...
Are you using Netview Access Services or NETVIEW? AFAIK, EMSMODE a Netview
Access Service Logmode table.
Do you see any IEV043* message?
AFAIK, changes in logmode need a stop/start in Netview Access Service
accompanied by a V NET,majnode INACT and ACT if needed.
I am not sure how HOD is working, I have never worked with that.
Groete / Greetings
Elardus Engelbrecht
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
