On 6/4/2015 1:03 PM, Joanne Nicolazzo wrote:
On Thursday, June 4, 2015 at 11:49:56 AM UTC-4, Jim Brooks wrote:
One can NOT delete an online device.
Regards,
Jim
On Thu, Jun 4, 2015 at 11:27 AM, Thomas Conley <[email protected]>
wrote:
On 6/4/2015 11:14 AM, Joanne Nicolazzo wrote:
On Thursday, June 4, 2015 at 10:39:08 AM UTC-4, Joanne Nicolazzo wrote:
Hi Everyone,
We just migrated to a new disk array; migration went smoothly and
yesterday I removed the old disk from my gen. I noticed when I was in there
that I had neglected to specify LOCANY=YES on the new disk. Not a huge deal
but one job did fail with an 822 so I want to clean it up before the
weekend.
So I created a new IODF changing all the new disk to LOCANY=YES, but
when I tried to test the activation I got the following messages for each
and every new disk device that I had just changed:
0090 IOS500I ACTIVATE RESULTS 878
0090 TEST DETECTED CONDITIONS WHICH WOULD RESULT IN ACTIVATE FAILURE
0090 NOTE = 0100,SOFTWARE-ONLY CHANGE
0090 COMPID=SC1C3
0090 REASON=0152,CAN NOT DELETE DEVICE 7000
0090 DESCTEXT=DEVICE ONLINE
0090 COMPID=SC1C3
0090 REASON=0152,CAN NOT DELETE DEVICE 7001
0090 DESCTEXT=DEVICE ONLINE
0090 COMPID=SC1C3
0090 REASON=0152,CAN NOT DELETE DEVICE 7002
0090 DESCTEXT=DEVICE ONLINE
0090 COMPID=SC1C3
0090 REASON=0152,CAN NOT DELETE DEVICE 7003
0090 DESCTEXT=DEVICE ONLINE
I've checked and re-checked and the devices are in the IODF. The only
difference is the LOCANY=YES.
Does anyone have any ideas what I've missed?
Thanks very much,
Joanne Nicolazzo
I also did an HCD compare and verified that the LOCANY=YES from LOCANY=NO
was the only difference between the two IODF's.
Were they defined as DYNAMIC?
Regards,
Tom Conley
No I wasn't trying to delete the devices. I was only trying to change them from
LOCANY=NO to LOCANY=YES.
I deleted the old devices. So what if I do an IPL? Or do I at this point have
to do a POR?
Joanne,
You should not have to POR or IPL to modify LOCANY. Were the devices
defined as DYNAMIC YES? If so, then you should open a PMR with IBM. If
not, then you'll need to IPL each LPAR with a new IODF to enable DYNAMIC.
Regards,
Tom Conley
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: INFO IBM-MAIN
