Ok, I believe I understand. In which case, are the DDDEFs for the target libraries the only DDDEFs in your target zone with VOLUME pointing at your sysres? If so can't you use ZONEEDIT with a conditional? (SMP/E Commands Manual has an example).
Regards Andy T. On 3 Sep 2014, at 10:21, Mainframe Mainframe <[email protected]> wrote: > Thanks for reply. But I am not looking for single DDDEF entry. I want to > update all target dataset DDDEF using single JCL. I don't want to do it > manually. As this will consume lots of time. > > > On Wed, Sep 3, 2014 at 2:42 PM, Andy Taylor <[email protected]> > wrote: > >> Hello >> >> Not quite sure why you think you can't update a single DDDEF entry, but is >> it because you're looking at the ZONEEDIT command as opposed to the UCLIN >> command? UCLIN will allow you to update a single DDDEF entry. >> >> Regards >> >> Andy T. >> >> >> On 3 Sep 2014, at 09:36, Mainframe Mainframe <[email protected]> >> wrote: >> >>> We have two copies of RES volume. Primary and Secondary in our z/OS 1.13 >>> systems.While setting up SMPE initially, we always make sure that SMPE >>> DDDEF of target dataset should point to only Alternate RES volume and we >>> always run system with primary RES volume. >>> >>> So, while applying Maintenance new data will go into Alternate RES >> volume, >>> and running system will not be affected. >>> >>> But, I just saw that in one of our system, Target dataset DDDEF is not >>> pointing to Alternate RES volume. But as we have indirectly catalogging >>> setup, So, target zone DDDEF pointing that RES volume using that system >>> is IPL'd currently. >>> >>> But Now I have requirement of changing Target zone DDDEF to point to Alt >>> RES volume permanently . But my difficultly is, if I use CHANGE VOLUME by >>> setting up BDY as target zone then it will change all target and >>> distribution dataset present in target zone which I dont want. Is there >> any >>> procedure, to change only Target dataset volume and UNIT parameter in >>> target zone. >>> >>> ---------------------------------------------------------------------- >>> For IBM-MAIN subscribe / signoff / archive access instructions, >>> send email to [email protected] with the message: INFO IBM-MAIN >> >> ---------------------------------------------------------------------- >> For IBM-MAIN subscribe / signoff / archive access instructions, >> send email to [email protected] with the message: INFO IBM-MAIN >> > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
