Thanks for reply. But I am not looking for single DDDEF entry. I want to update all target dataset DDDEF using single JCL. I don't want to do it manually. As this will consume lots of time.
On Wed, Sep 3, 2014 at 2:42 PM, Andy Taylor <[email protected]> wrote: > Hello > > Not quite sure why you think you can't update a single DDDEF entry, but is > it because you're looking at the ZONEEDIT command as opposed to the UCLIN > command? UCLIN will allow you to update a single DDDEF entry. > > Regards > > Andy T. > > > On 3 Sep 2014, at 09:36, Mainframe Mainframe <[email protected]> > wrote: > > > We have two copies of RES volume. Primary and Secondary in our z/OS 1.13 > > systems.While setting up SMPE initially, we always make sure that SMPE > > DDDEF of target dataset should point to only Alternate RES volume and we > > always run system with primary RES volume. > > > > So, while applying Maintenance new data will go into Alternate RES > volume, > > and running system will not be affected. > > > > But, I just saw that in one of our system, Target dataset DDDEF is not > > pointing to Alternate RES volume. But as we have indirectly catalogging > > setup, So, target zone DDDEF pointing that RES volume using that system > > is IPL'd currently. > > > > But Now I have requirement of changing Target zone DDDEF to point to Alt > > RES volume permanently . But my difficultly is, if I use CHANGE VOLUME by > > setting up BDY as target zone then it will change all target and > > distribution dataset present in target zone which I dont want. Is there > any > > procedure, to change only Target dataset volume and UNIT parameter in > > target zone. > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
