The UXTB is for the RMM version of the CA-1 RDS process.
"Confidentially doc, I am the wabbit." Bugs Bunny Sent with Proton Mail secure email. On Thursday, May 15th, 2025 at 9:51 AM, rpinion865 <[email protected]> wrote: > I think you need to run a DFRMM STC which will set up the UXTB. Off the top > of my head, I cannot > remember what STC does that. Maybe my suggestion will ring a bell for you. If > not, I can find out > what STC you need to run. > > > > "Confidentially doc, I am the wabbit." > > Bugs Bunny > > Sent with Proton Mail secure email. > > > On Thursday, May 15th, 2025 at 9:47 AM, Jay Maynard > [email protected] wrote: > > > We're having a weird problem. On our QA LPAR, trying to do a tape mount > > (for an FDRABR restore operation) results in the following messages > > after the IEF455D for the tape mount: > > > > EDGI100I SUBSYSTEM UXTB NOT DEFINED OR NO TABLE LOADED > > EDG2003E ABEND S0C4 U0000 RSN 0017 DURING DFSMSrmm SUBSYSTEM PROCESSING AT > > 4C0DFA IN MODULE K j~ > > EDG4003E DFSMSrmm DETECTED CONTROL BLOCK ERROR 20, 4084 DURING OPEN FOR > > VQ0002 BY TXNWABRR, UTABRRES, TAPE# > > > > Everything we can find about the EDGI100I message talks about using > > EDGUX100 to set up processing for tape expiration. We had, at some point in > > the past, had that exit in place and the associated table, but during the > > installation of a previous z/OS, converted that to using the > > EDGDEF00 member to accomplish the same goal and removed the exit and the > > table. > > > > The annoying thing about this is that this all works perfectly in our > > production LPAR. We've compared definitions and modules between the two > > LPARs, and they're the same. > > > > So...anyone have any suggestions as to where we can look? Why does RMM > > issue EDGI100I if the exit is not in use? I've tried looking at the 0C4 > > dump, and it wasn't very enlightening. We've contacted BMC just to make > > sure it's not FDR that's the culprit, and they found that it's the victim, > > and pointed us to the same web page we keep tripping over at > > https://ibm.com/support/pages/rmm-message-edgi100i-issued . > > -- > > Jay Maynard > > > > ---------------------------------------------------------------------- > > For IBM-MAIN subscribe / signoff / archive access instructions, > > send email to [email protected] with the message: INFO IBM-MAIN > > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
