It's always advisable to read the HOLDDATA, often these are advisory in nature, could be "check region size is a minimum" or "these parameters are now obsolete and will be ignored". If you are happy that you understand the hold reasons, as previous posters said you can BYPASS.
On Sat, Sep 4, 2021 at 9:28 AM Retired Mainframer < [email protected]> wrote: > At my last site, the Quality Control folks would not accept anything > higher > than a four on a job they were required to review. This was a result of > some > product teams bamboozling them on 8s and 12s in the past. Management did > not > like it when the customers discovered delivery errors. Once QC was > required > to review system updates as part of new security practices, 4 became the > limit > for SMPE also. > > -----Original Message----- > From: IBM Mainframe Discussion List <[email protected]> On Behalf > Of > Mark Jacobs > Sent: Friday, September 3, 2021 10:26 AM > To: [email protected] > Subject: Re: SMPe GIM30206E > > Look at the SMP/e CAUSER report and see what is/are the hold reasons. Then > it > depends on what they are. Bypass or not. There's no need to exclude them. > Just > expect an RC=8 on the apply. > > Mark Jacobs > > ---------------------------------------------------------------------- > For IBM-MAIN subscribe / signoff / archive access instructions, > send email to [email protected] with the message: INFO IBM-MAIN > -- Wayne V. Bickerdike ---------------------------------------------------------------------- For IBM-MAIN subscribe / signoff / archive access instructions, send email to [email protected] with the message: INFO IBM-MAIN
