Hi Saurabh,
I haven't followed this one much so I hope I am not repeating earlier advice,
but ACNMLINK certainly won't work - you need your target library for sure
(lowest level qualifier CNMLINK - I can't remember the prefixes, but it might
be TLIB.NV390.V5R3.CNMLINK for you) and it must be authorised. (note that
CNMINIT in ACNMLINK is not AC=01, but in CNMLINK it is). You also need a NETV
subsystem set up in your IEFSSNxx member - SUBSYS SUBNAME(NETV).
Best regards,
David Tidy
IS Technical Management/SAP-Mf
Dow Benelux B.V.
-----Original Message-----
From: IBM Mainframe Discussion List [mailto:[email protected]] On Behalf Of
saurabh khandelwal
Sent: 24 November 2011 07:40
To: [email protected]
Subject: Re: NetView Startup problem
Hello,
I added my STEPLIB libraries to ROG00 and IPL'd system again.
but still getting same error ..
I have added DLIB.NV390.V5R3.ACNMLINK dataset on my PROG member.
RC S0C4 and resason code 11 for below step.
----------------------------------------------------------------------
For IBM-MAIN subscribe / signoff / archive access instructions,
send email to [email protected] with the message: GET IBM-MAIN INFO
Search the archives at http://bama.ua.edu/archives/ibm-main.html
