Steve Kargl <s...@troutmask.apl.washington.edu> writes:
> On Tue, Jun 24, 2014 at 10:26:27PM +0200, FX wrote:
>> >> 3. Does the attached updated patch (libgfortran only, without
>> >> regenerated files) fix the problem?
>> >
>> > I'll test it when my regtesting is completed. But, a scan of
>> > the configure.host re-arrangement suggests that it should work.
>>
>> OK.
>>
>> If you have some spare cycles, could you then also check it by modifying
>> configure.host so that it uses the updated config/fpu-sysv.h in my patch? I
>> would like to make sure I don?t break anything, but I don?t have access to a
>> Solaris system (and my earlier calls for someone to test it for me were
>> unanswered, so I don?t have much hope there).
>>
>
> Yes, I'll check the configure.host and fpu-sysv.h changes.
I'm currently moving to a new flat, so not much time for GCC work.
Unfortunately, while the patch works fine on Solaris/x86, it broke
Solaris/SPARC bootstrap for trivial reasons: contrary to the ChangeLog,
configure and config.h.in weren't regenerated, thus FPSETSTICKY
wasn't defined.
The following patch corrects this, at the same time fixing this warning:
/fpu-target.h:451:3: warning: implicit declaration of function 'assert'
[-Wimplicit-function-declaration]
assert (sizeof(fpu_state_t) <= GFC_FPE_STATE_BUFFER_SIZE);
^
It returns sparc-sun-solaris2.1[01] to bootstrap, thus installed as
obvious.
There's one testsuite failure in this configuration:
FAIL: gfortran.dg/ieee/ieee_6.f90 -O0 execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O1 execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O2 execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O3 -fomit-frame-pointer execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O3 -fomit-frame-pointer -funroll-loops
execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O3 -fomit-frame-pointer -funroll-all-loops
-finline-functions execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -O3 -g execution test
FAIL: gfortran.dg/ieee/ieee_6.f90 -Os execution tes
The test aborts at l.47, but unfortunately I cannot print mode in gdb 7.7.
Rainer
2014-07-05 Rainer Orth <r...@cebitec.uni-bielefeld.de>
* configure, config.h.in: Regenerate.
* config/fpu-sysv.h: Include <assert.h>.
diff --git a/libgfortran/config/fpu-sysv.h b/libgfortran/config/fpu-sysv.h
--- a/libgfortran/config/fpu-sysv.h
+++ b/libgfortran/config/fpu-sysv.h
@@ -25,6 +25,8 @@ see the files COPYING3 and COPYING.RUNTI
/* FPU-related code for SysV platforms with fpsetmask(). */
+#include <assert.h>
+
/* BSD and Solaris systems have slightly different types and functions
naming. We deal with these here, to simplify the code below. */
--
-----------------------------------------------------------------------------
Rainer Orth, Center for Biotechnology, Bielefeld University
