Hello everyone, I am currently working with ADC values extracted from inhomogeneity bias-corrected ADC MRIs obtained through SAMSEG and have encountered a few issues that I would greatly appreciate your insights on.
1. Units for ADC Values: When extracting ADC values for my ROIs, using 3D Slicer, I noticed that no unit was provided for the ADC values, neither in the software nor in the imaging visualization tools (PACS, VISAGE). I also checked the DICOM metadata for ADC and DWI MRIs but could not find any relevant tags related to ADC values, rescaling, or intersection. As a result, I am uncertain about the unit or scale used for the ADC values. 2. Discrepancy in ADC Value Range: The mean ADC values extracted from the bias-corrected image for my ROIs were in the range of 150-250. These values seem far away from the normal average ADC values for these structures. I suspected that the bias correction might have influenced these values, so I also extracted the values from the original ADC image. In this case, the values ranged from 1200-1500 for ROIs. However, I still could not identify any unit or rescaling factor. Considering that the average normal ADC values for my ROI are around 1000 to 1500 x 10-6 mm²/s, I have two questions: For extracting radiomics features (including ADC values) from the ADC image, would you recommend using the bias-corrected image or the original ADC image as the scalar volume? Based on the values I found, there must be a rescaling factor (like 10-6). Would you happen to know where I might find the rescaling factor, or how I could confirm it? I would greatly appreciate any guidance you could provide on these issues. Thanks, Nima
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline <https://www.massgeneralbrigham.org/complianceline> . Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.
