External Email - Use Caution Hi,
My name is Chemda Wiener. I am a PhD student in a Neuro-Engineering lab. We are working with MRI scans of patients with epilepsy and I am attempting to use freesurfer to create the mesh .pial files. When I run the freesurfer recon-all command, the command gets stuck at "correcting defects" with the last file it creates being the "lh.defect_chull". It has been stuck for a few days on this part until I finally killed the process. I tried running autorecon2 afterwards on this patient to see if it can pick up from where it stopped but it gets stuck again at the same place. I would appreciate any help in the matter. Thank you in advance for your time and your software! Chemda
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Mass General Brigham Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline <https://www.massgeneralbrigham.org/complianceline> . Please note that this e-mail is not secure (encrypted). If you do not wish to continue communication over unencrypted e-mail, please notify the sender of this message immediately. Continuing to send or respond to e-mail after receiving this message means you understand and accept this risk and wish to continue to communicate over unencrypted e-mail.
