Currently, you'd have to convert them to t1-weighted images and then
run recon-all on that. I think there is software out there to do this if
you go the t1 maps from an mp2rage scan
On 1/25/2024 11:57 AM, AJ wrote:
External Email - Use Caution
Hi,
I have T1 relaxation maps over 4 time points. In terms of longitudinal
analysis, could these maps be fed into Freesurfer longitudinal
pipeline to control for intersubject variability of signal intensity?
Any other method you would recommend?
Many thanks
AJ
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Mass General Brigham
Compliance HelpLine at https://www.massgeneralbrigham.org/complianceline
<https://www.massgeneralbrigham.org/complianceline> .
Please note that this e-mail is not secure (encrypted). If you do not wish to
continue communication over unencrypted e-mail, please notify the sender of
this message immediately. Continuing to send or respond to e-mail after
receiving this message means you understand and accept this risk and wish to
continue to communicate over unencrypted e-mail.
