how are you verifying that it is not in the right place? You should view
it on the 2mm MNI152 using freeview. Also, your label should be a label
in fsaverage space.
On 3/27/18 9:52 AM, gj wrote:
> Hi,
>
> Newbie question....I want to take FreeSurfer labels (from an atlas in
> fsaverage space) and convert it into a volumetric NIFTI mask. I ran the
> following command, but I must be missing something because the output is
> not in the right space (far too posterior):
>
> $FREESURFER_HOME/bin/mri_label2vol \
> --label $ll \
> --temp $FSLDIR/data/standard/MNI152_T1_2mm.nii.gz \
> --reg $FREESURFER_HOME/average/mni152.register.dat \
> --fillthresh .5 \
> --o $wd/${ll}.nii
>
> Am I perhaps supposed to first create the volumetric file without
> mapping into MNI space and then use tkregister2?
>
> Thanks in advance for any help or advice!
> Gina
> _______________________________________________
> Freesurfer mailing list
> Freesurfer@nmr.mgh.harvard.edu
> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
