Hi – There are a few places in the config file where the variable “$TUTORIAL_DATA” is referenced. Do you define that variable on your own before your run trac-all? If not, you have to edit the config file and replace it everywhere with the path to where you saved the tutorial data on your computer.
From: <freesurfer-boun...@nmr.mgh.harvard.edu<mailto:freesurfer-boun...@nmr.mgh.harvard.edu>> on behalf of Renew Andrade <andradere...@yahoo.com<mailto:andradere...@yahoo.com>> Reply-To: Freesurfer support list <freesurfer@nmr.mgh.harvard.edu<mailto:freesurfer@nmr.mgh.harvard.edu>> Date: Wednesday, January 31, 2018 at 3:16 PM To: "freesurfer@nmr.mgh.harvard.edu<mailto:freesurfer@nmr.mgh.harvard.edu>" <freesurfer@nmr.mgh.harvard.edu<mailto:freesurfer@nmr.mgh.harvard.edu>> Subject: [Freesurfer] Yendiki Anastasia config file Here is the configuration file. I think is the default by tutorial.
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
