Hi, I have a MT and T1W volume (processed through recon-all). I would like to extract all MT values that lie in the middle surface of the cortex, and run that through mri_segstats so I get average MT values for each cortical region in the DK-atlas.
My workflow is as follows: 1. mri_vol2suf --mov <MT_vol> --hemi lh --projfrac 0.5 -- regheader <id> --reg <MT_reg_to_T1W.dat> --o <vol2surf.output.mgh> --interp nearest 2. mri_surf2vol --surfval <vol2surf.output.mgh> --hemi lh --fillribbon --identity <id> --template <T1W> --o <surf2vol.output.mgh. 3. mri_segstats --seg <aparc+aseg for subid.mgz> --i <surf2vol.output.mgh> --ctab --id <list of regions> --o <output.stats> Is this the correct way of going about it? I was wonder if its alright to use mri_vol2surf to get MT values on a T1W surface, and then mri_surf2vol to get the output from vol2surf into a T1W cortical ribbon. And finally run mri_segstats on the output of mri_surf2vol using the aprac+aseg for that subject. Thank you, Yash RRI, Baycrest Health Sciences University of Toronto
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
