sure, but I'll need the subject as well (at least one surface)
On Wed, 31
May 2017, Daniel Yang wrote:
Good to know, then, it must be the way I interact with FS 6.0.0 that is wrong.
It’s a surface label.
Can I send you the label file to see if you could view that in FS 6.0.0’s
freeview using command line?
--
Y.J. Daniel Yang, Ph.D.
Assistant Research Professor
Autism and Neurodevelopmental Disorders Institute
The George Washington University and Children’s National Health System
E-mail: daniely...@gwu.edu
On May 31, 2017, at 1:37 PM, Bruce Fischl <fis...@nmr.mgh.harvard.edu>
wrote:
no, the label format should be backwards compatible. Was it a surface or volume
label?
On Wed, 31 May 2017, Daniel Yang wrote:
Dear FreeSurfer experts,
When I tried to use FreeSurfer 6.0.0’s freeview to open a label file
generated by FreeSurfer 5.3, I could not see anything.
Is it incompatibility issue going on here?
Thanks,
Daniel
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
