On 22 May 2017 at 07:39, Ramesh Babu <mgrameshbabu2...@gmail.com> wrote:
> The following last line get repeated same way except (%) in the second line > pasted below. On the third line "Did not call MRIsetResolution", is it error > or normal process? Since repeated many times I thought there is some error. > > PutOnGPU: Did not reset gca in dst > 0270: dt=9.072001, rms=0.557 (0.021%), neg=0, invalid=762 > LabelTerm: Did not call MRIsetResolution That's completely normal - it was sort of an aide-memoire for myself. Should things start messing up in interesting ways, that might be something to go and check (at the time I did the port, it was a no-op for the command I was running). So long as the nnn: dt=.... lines are popping out OK, it's running. Richard _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
