Hi Tamara, 

in the base it is good the check the brain mask, as it is used for all time 
points (it is fixed over time). 
To check alignment accuracy, you could use either brain mask or norm. It should 
not make a difference. It will be hard to find problems in that image (the 
blurriness will be difficult to see, unless you see ghost images etc).  
Therefore, to really check alignment, you would need to open the all 
longitudinal runs on to of the base and go through them one by one (I would 
recommend to use norm.mgz). FreeView has a opacity slider, that I use to blend 
from one time point to the next (or to the base). That way you can see motion 
better. 
There are non-linear distortions in these images, so only if you see a clear 
global rotation or translation you need to worry. 

Best, Martin

> On Nov 10, 2016, at 8:28 PM, Tamara Tavares <ttav...@uwo.ca> wrote:
> 
> Thank you for the clarification Martin
> 
> I have a follow-up question. When I load the base to  make sure it doesn't 
> look blurry, should I check the norm.mgz or brainmask.mgz? Online says 
> norm.mgz but I just want to make sure. Also, would the "blurriness" be 
> obvious? 
> 
> Similarly, when I open the base and the longitudinal runs to see whether they 
> align, again should I load the brainmask.mgz for these as well?
> 
> Thank you in advance for your help,
> Tamara
> _______________________________________________
> Freesurfer mailing list
> Freesurfer@nmr.mgh.harvard.edu
> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer

_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer


The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.

Reply via email to