No, you can use version 6.0 dt_recon with anat analyses from any FS version
On 11/12/16 3:26 PM, John Anderson wrote:
Dear Freesurfer experts,
I want to analyze DTI data using the command
*dt_recon --i dwi.nii --b bvals bvecs --s subj1 --o /subj1*
Under Fressurfer 5.3, the analysis fail showing this error message:
nifti1Read(): unsupported slice timing pattern 5 in
/data/anaconda/mesgp/dtrecon3/subj1/dwi.nii
I re-run the same previous comand line under freesurfer 6 and the
nalysis went fine.
The problem is that all my recons are prepared under freesurfer 5.3.
If I use dt_recon under FS6 does this affect the results?
Thank you for any advice you provide!
Bests,
John
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
