I use Freeview on a daily basis as my primary image viewer. I like it a lot and found it to be tremendously useful. I am usually interested in opening images in the current directory where I launched Freeview from the command line. I know you can load multiple images at once from the command line but occasionally I want to load an additional image. Ideally, I would like Freeview when I want to load a volume to open up the file explorer tool in the current directory. Instead, it opens up in another directory and I have to click down several directories before finding the file that I want. Freeview has been consistently opening up in the same directory. I just can’t figure out why it picks that directory.
If someone could tell me if it is possible for Freeview to open the file browser in the directory it was launched I would be extremely grateful. Thanks for your help in advance, Bob _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
