tksurfer always uses the ?h.orig coordinates. Also keep in mind that the
vertex index is 0-based whereas matlab is 1-based. When you click on a
point, you should see something like the following print out
selected vertex 123491 out of 163842
current -39.11 15.65 11.26
orig -55.67 -10.37 19.95
pial 0.00 0.00 0.00
white -55.76 -10.29 19.93
On 8/30/16 5:12 AM, Dongnandi wrote:
Dear Experts,
I tried to extract vertex coordinates information from
‘fsaverage/surf/lh.pial’ file using matlab function ‘read_surf’, but I
found that the coordinates returned by the function are different from
what I saw in tksurfer, here are the screenshots:
The vertex index starts from 0 in tksurfer, so I select the second
elements in matlab. Why is the result different from what has been
shown in tksurfer(also different in freeview)? Which one should I report?
Is there any way to transform the surface coordinates to the MNI152 space?
Thank you very much!
Dong
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
