Hi everyone, I'm using mri_convert to reinforce TR information into the Nifti header in the following manner:
mri_convert $FILE $FILE -tr $TR Before the conversion, my file size is usually around 550MB but after the conversion is doubles in size to ~1.1GB. In the Nifto file header I've noticed that the data type usually changes from int16 to float32. Is there a quick way to decrease the file size or revert back to int16 without affecting the data? Thanks for you help, Afsana ______________________________ Afsana Afzal Clinical Research Coordinator Massachusetts General Hospital Division of Neurotherapeutics Department of Psychiatry: Neurosciences 149 13th St, Room 2612 Charlestown, MA 02129 Phone: 617-643-5129 Fax: 617-726-4078
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
