Thank you! > Hi Angela > > you can load it into matlab with read_curv. If you have the surface and > the > tal xform (or transform the surface before loading it into matlab) you can > find the point on the surface that is closest to a given tal coord and > read > out the sulc at that point > cheers > Bruce > On Wed, 23 Sep 2015, > angela.fav...@unipd.it wrote: > >> Hi all, >> is there any way (different from manually looking in tksurfer) to know >> the >> value of 'sulc' (or other) in a particular point Talaraich xyz of a >> subject? >> >> Thank you! >> >> Angela >> >> >> _______________________________________________ >> Freesurfer mailing list >> Freesurfer@nmr.mgh.harvard.edu >> https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer >> >> >> > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > > The information in this e-mail is intended only for the person to whom it > is > addressed. If you believe this e-mail was sent to you in error and the > e-mail > contains patient information, please contact the Partners Compliance > HelpLine at > http://www.partners.org/complianceline . If the e-mail was sent to you in > error > but does not contain patient information, please contact the sender and > properly > dispose of the e-mail. > >
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
