I think the topology is constrained to be correct - are you sure there is an error? And I guess I would try smoothing in freeview Cheers Bruce
> On Apr 19, 2015, at 8:29 PM, Jonathan DuBois <jonathan.m.dub...@gmail.com> > wrote: > > Hi Bruce, > > Thanks. It took some trial and error but I was able to fix the surface with > the reposition surface tool. However, it results in a fairly jagged surface > with some topology error. To correct this, should I use the smooth surface > tool in freeview or reprocess the surfaces with recon-all? Thanks agian > > Jonathan > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
