Hi all, I have structural data that has a slice thickness of 5mm and spacing between slices of 5mm (there are around 30 dicom images). I ran it through recon-all but the output was bad. Is it possible to create surfaces from such data? Or is the bad output the answer to this question...
Thanks, Will
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
