Dear all,
I have a question regarding the pre-prossesing steps of DTI data.
I have 5 different datasets, each with different acquisition parameters, including the number of directions (16, 32 and 64), the b-value (1000, 1300 and 1500) and the magnetic field (1.5 and 3T). Do you think that a single pre-processing procedure can be applied to all of them? or it will vary depending on the acquisition parameters?
A second question would be, if the pre-processing steps of FS include some distortion correction using a high-resolution image? If so, could it be replaced by the T2 or a b0?
Can you point me to the correct literature of this?
Many thanks in advanced for your time and help,
Gabriel
I have a question regarding the pre-prossesing steps of DTI data.
I have 5 different datasets, each with different acquisition parameters, including the number of directions (16, 32 and 64), the b-value (1000, 1300 and 1500) and the magnetic field (1.5 and 3T). Do you think that a single pre-processing procedure can be applied to all of them? or it will vary depending on the acquisition parameters?
A second question would be, if the pre-processing steps of FS include some distortion correction using a high-resolution image? If so, could it be replaced by the T2 or a b0?
Can you point me to the correct literature of this?
Many thanks in advanced for your time and help,
Gabriel
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
