Hi Emad,
In your recon-all command what does 03551671 correspond to? I don't see
03551671 in the scan.info file corresponding to any of the runs. I think
you want to use 03557285. Also, run 26 apparently has 176 frames which
shouldn't be the case.
-Louis
On Wed, 4 Jun 2014, Emad Ahmadi wrote:
Hello,
I’m trying to unpack and run recon-all on a set of MEMPRAGE images we’ve
obtained in Lunder 6 scanner (Siemens Skyra), but recon-all is giving me
errors. I’ve attached for the scan.info file (outputted by unpacksdcmdir), the
unpack.config file that I used to unpack the MEMPRAGE images, and the
recon-all.log file containing the error that recon-all command gives me. I’m
running recon-all on in MEMPRAGE3 folder containing MEMPRAGE_IPAT3 RMS images.
Please let me know if I have to provide any further info about this problem.
Thank you very much for your help,
Emad
Emad Ahmadi, MD
-----------------------------------------------
Postdoc Research Fellow
Department of Radiology
Massachusetts General Hospital
Harvard Medical School
25 New Chardon Street, Suite 400
Boston, MA 02114
Tel: 617 726 5237
Email: e...@nmr.mgh.harvard.edu
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
