Dear FS experts,
I have a very strange error after running autorecon2-cp. I never saw this kind of error with previous versions of FS. I run recon-all -all on my subject, and obtained very good surface reconstructions, with the exception of few excluded wm voxels (see attachment called "before autorecon2-cp"). I added few control points throughout the entire image (for a total of 20 control points) and I run -autorecon2-cp -autorecon3 on the same subject. The output I obtain is very bad (see attachment called "after autorecon2-cp"). How is it possible that adding 20 control points causes such a surface distortions?!! I never had this error with previous FS versions. Thank you for any suggestion. Kind regards, Paola
<<attachment: Example_FS_slice140_beforeA2cp.jpg>>
<<attachment: Example_FS_slice140_afterA2cp.jpg>>
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
