I've seen this happen after making manual edits and then not finishing a
re-run of recon-all.
Chris
On 12/10/2013 02:00 PM, Laura Taylor wrote:
Hi,
I'm trying to load lh.aparc.a2009s.annot onto the lh pial surface of a
subject. When I use the freeview gui and select lh.aparc.a2009s.annot
under the annotations menu a strange multicolored surface is loaded.
It looks like something that has been tie-dyed and not like the
examples of parcellation that are shown on some of the freesurfer pages.
I have attached a screenshot of the output that I get.
Any help would be appreciated.
Thank you,
Laura
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
