yes, with "-s subjects" replaced with "-s <subject id>"
On Tue, 10 Dec 2013, Rujing Zha wrote:
Dear all, Can I just type "recon-all -autorecon-pial -autorecon3 -s subjects" after editing the pial by PialEdit_tktools? All the best 2013-12-10 ____________________________________________________________________________ Rujing Zha School of Life Science University of Science and Technology of China E-mail: zh...@mail.ustc.edu.cn charuj...@gmail.com charujing...@163.com ____________________________________________________________________________ 发件人："Rujing Zha" <zh...@mail.ustc.edu.cn> 发送时间：2013-12-10 12:03 主题：[Freesurfer] after PialEdit_tktools 收件人："freesurfer"<freesurfer@nmr.mgh.harvard.edu> 抄送： Dear all, I run "recon-all -autorecon-pial -s subjects" after editing the pial by PialEdit_tktools. However I only find "-autorecon2-pial" option in recon-all manual. So I donot know whether I should run the "recon-all -s subjects -autorecon3" to complete all the 31 stages? Thanks. All the best. 2013-12-10 ____________________________________________________________________________ Rujing Zha School of Life Science University of Science and Technology of China E-mail: zh...@mail.ustc.edu.cn charuj...@gmail.com charujing...@163.com
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
