Hi, I'm using FS 5.3 and trying to use hires T2-weighted scans to refine the pial mesh.
However, I've found that using the T2 is causing rather dramatic problems with the pial surface. I processed the same subject's data with and without the -T2pial option. Here are links to a) pial surface image b) slices through the volume and c) the recon-all.log: With -T2pial ---------------- https://dl.dropbox.com/s/rtjgplajfptr4xb/bad_surf_withT2.png https://dl.dropbox.com/s/d7so5qtujgg8j80/bad_slice_withT2.png https://dl.dropbox.com/s/7o00jy014hihrgu/recon_log_withT2.txt Without -T2pial -------------------- https://dl.dropbox.com/s/51y15kogecltfbi/bad_surf_noT2.png https://dl.dropbox.com/s/3gps45kp0ngkuli/bad_slice_noT2.png https://dl.dropbox.com/s/6jih6f8fh4nwh0k/recon_log_noT2.txt The release notes for 5.3 claim that the T2 is registered to the T1 before refining the surface, but I actually can't find any evidence of that sequence in the log file. For this subject, the T1 and T2 came from different scan sessions, although I have other data where they were acquired in the same session that have similar, if less dramatic, problems with the pial surface. Any ideas? Michael
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
