Dear freesurfers,
I have a general question concerning *recon-all -i*.
Suppose under the subject *Beth*, there are 256 files:
Beth1.1.ima, Beth1.2.ima, Beth1.3.ima, ..., Beth1.128.ima
Beth2.1.ima, Beth2.2.ima, Beth2.3.ima, ..., Beth2.128.ima
I understand that I can use the following command to import the data
*recon-all -s Beth -i /Path_to_Beth/Beth1.1.ima*
* -i /Path_to_Beth/Beth2.1.ima*
which gives 001.mgz and 002.mgz in the Beth/mri/orig/
Now what if I rename the sequence as follows,
Beth2.1.ima -----> Beth1.129.ima
Beth2.2.ima -----> Beth1.130.ima
......
Beth2.128.ima -----> Beth1.256.ima
and import using *recon-all -s Beth -i /Path_to_Beth/Beth1.1.ima, *leading
to 001.mgz alone.
Would it make a difference?
Thank you very much!
Sincerely,
Ye
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
