Dear FS experts,
By definition bblabel means..
Applies a bounding box to a label. The bounding box is specified by
six coordinates (xmin,xmax,ymin,ymax,zmin,zmax). Only those label
points within this box are copied to the output. If a min is not
specified, then -infinity is used. If a max is not specified, then
+infinity is used.
Example:
bblabel --l lh.G_cuneus.label --o lh.out.label \
--xmin 0 --ymax -90 --zmin 10 --zmax 20
Keeps label points from lh.G_cuneus.label that have x > 0, y > -90,
and z between 10 and 20. The result is stored in lh.out.label.
IN THE ABOVE MENTIONED EXAMPLE, WHAT IS THE BASIS FOR THE SELECTION OF X, Y, Z
VALUES??
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
