Dear freesurfer experts, I am new to freesurfer and I want to project my single-subject MVPA (obtained in Matlab) results on a single-subject brain surface with curvature. I followed the steps from the tutorial: - reconstructed individual subject's brain surface - wrote my MVPA results map as a nifti image - resampled the map onto the surface
Now I want to visualize it. The tutorial (http://ftp.nmr.mgh.harvard.edu/fswiki/FsTutorial/NavigateResampledParametricMap) suggests to use qsurfer, however I don't seem to have this command. I tried to open the surface with tksurfer and then load the overlay, as described in the tutorial on visualization. However, when I open an inflated surface file, both buttons "show overlay" and "show curvature" are not active (though I have the .sulc file in the /surf). This is probably a very simple question, but I am stuck here. I would appreciate any advise on how to do the visualization: either from the command line or with tksurfer tools. thank you, kind regards, Irina Simanova _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
