Hello Gregory, The radius of the circular region is 25 mm by default. If you want you can change it, but I will not advise radii below 20 mm or above 30 mm.
Best, Marie On May 13, 2013, at 11:44 AM, Gregory Kirk <gk...@wisc.edu> wrote: > > Hello > > Im preparing an LGI(local gyrification index) manuscript and seems i don't > know the default radius that is used for the circular region defined on the > outer surface > that the boundary of is then projected onto the pial surface to get the > corresponding pial region ? > > hope im clear, not the radius of the closing operator. > > thank you > > Greg > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > > The information in this e-mail is intended only for the person to whom it is > addressed. If you believe this e-mail was sent to you in error and the e-mail > contains patient information, please contact the Partners Compliance HelpLine > at > http://www.partners.org/complianceline . If the e-mail was sent to you in > error > but does not contain patient information, please contact the sender and > properly > dispose of the e-mail. > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
