Hi Stefano, You dont need to-- the thickness measures are created by the mris_preproc command with the --meas thickness flag and the file is saved in $PWD
Hth, Shantanu On Mon, February 25, 2013 6:03 am, std...@virgilio.it wrote: > Dear fs users, > I do not understand from tutorial if I should specify in > mris_preproc --fsgd file.fsgd \--target fsaverage --hemi lh \ > > --meas thickness \ > > --target fsaverage --hemi lh \ --o lh.thickness.mgh > > > > > > the .thickness directory for each subject after --meas thickness. If yes, > how can I do? > Thanks, > > Stefano > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer -- Shantanu Ghosh, Ph.D. Harvard Medical School & Massachusetts General Hospital Martinos Center for Biomedical Imaging _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
