Hello list,
is there a quick way to decimate an overlay /while respecting surface
geomery)? I am looking to downsample by about a factor 100.
Alternatively, I know I can use mris_decimate to downsample a surface,
but I would have to project my highres overlays onto the downsampled
surface (which may not be straightforward).
Thanks a lot in advance,
Nicola
PS apologies for the repost - my subject line was incorrect the first
time around.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
