Hi,
I am using the command to check my registration and getting this
error message: could not find orig as either mgz or COR. This is the
command I am using.
tkregister2 --mov 18135.RS.mgz --reg 18135_RS_register.dat --surf
----------------------------------------OUTPUT--------------------------------------------------
INFO: no target volume specified, assuming FreeSurfer orig volume.
target volume orig
movable volume 18135.RS.mgz
reg file 18135_RS_register.dat
LoadVol 1
ZeroCRAS 0
$Id: tkregister2.c,v 1.121.2.1 2011/03/28 20:25:16 greve Exp $
Diagnostic Level -1
---- Input registration matrix --------
-0.994 -0.040 0.100 2.799;
-0.097 -0.071 -0.993 2.262;
-0.047 0.997 -0.067 5.775;
0.000 0.000 0.000 1.000;
float2int = 0
---------------------------------------
ERROR: could not find orig as either mgz or COR
------------------------------------------------------------------------------------------------
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
