Hi Rouhollah
what resolution do you mean? You can use mris_fill to fill the interior
of the white and pial surfaces at whatever resolution you want, then
compute the AND of the two volumes in matlab, or perhaps using mri_mask or
something similar.
cheers
Bruce
On Thu, 13 Dec 2012, Rouhollah Abdollahi
wrote:
Dear Freesurfer experts,
I tried to create high resolution ribbon from pial and white surfaces. Actua
lly I found this question in mailing list but the answer was not clear. I ha
ve a register.dat file and white and pial surfaces. My aim is to create a h
igh resolution ribbon from those by using register.dat. What is the stream l
ine or commands to do that?
--
Best Regards
Rouhollah Abdollahi
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
