H,
I think the warning message says itself very clear :-). If you load a
volume after the surface, it might not align with it because of the lack
of geometry information in the surface header.
I'm not sure about your second question. Anyone?
Ruopeng
On 12/8/11 3:56 PM, kelsi wrote:
Hi,
when I load my ?h.white, inflated, pial, etc data in freeview, I keep
getting this message:
"Surface does not contain valid volume geometry information. It may
not align with volumes and other surfaces"
My command is:
freeview -v fsaverage/mri/aparc+aseg.mgz -f fsaverage/surf/lh.inflated
Also, is there inherent segmentation in the surface data, or do I have
to load it onto an aparc+aseg.mgz file in order to accurately label
the areas?
Thank you!
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
