yes, that will prevent it I believe. Or you can load them in freeview
from the interface (I believe they are a type of pointset in freeview)
On
Thu, 27 Oct 2011, Matt Glasser wrote:
Hi Bruce,
That didn't happen, but perhaps because I loaded the volume with -f instead
of the more standard way. I'll try it again.
Thanks,
Matt.
-----Original Message-----
From: Bruce Fischl [mailto:fis...@nmr.mgh.harvard.edu]
Sent: Thursday, October 27, 2011 12:53 PM
To: Matt Glasser
Cc: freesurfer@nmr.mgh.harvard.edu
Subject: Re: [Freesurfer] Viewing Control Points
Hi Matt
they will be loaded by default in tkmedit when you load any volume if the
file subject/tmp/control.dat exists.
cheers
Bruce
On Thu, 27 Oct 2011, Matt Glasser
wrote:
Hi,
Is it possible to view control points (in control.dat), that you already
created? If so, how do you do it?
Thanks,
Matt.
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the
e-mail
contains patient information, please contact the Partners Compliance
HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in
error
but does not contain patient information, please contact the sender and
properly
dispose of the e-mail.
_______________________________________________
Freesurfer mailing list
Freesurfer@nmr.mgh.harvard.edu
https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is
addressed. If you believe this e-mail was sent to you in error and the e-mail
contains patient information, please contact the Partners Compliance HelpLine at
http://www.partners.org/complianceline . If the e-mail was sent to you in error
but does not contain patient information, please contact the sender and properly
dispose of the e-mail.
