Hi Maria as long as the tal xform is reasonable I wouldn't worry about it, unless for some reason you care a lot about the accuracy of the talairach coords.
cheers Bruce p.s. not sure why it would be smaller On Fri, 9 Sep 2011, Maria Felber wrote: > Dear all, > > sorry, if that question came up before in the mailing list and I simple have > been unable to find the thread. > > Following the wiki reconstruction workflow, I ran yesterday the recon-all > -all process. The process finished without errors. So the next step was to > check the talairach transform. > Now, according to the FsTutorial/Talairach I have to make some adjustments > and then run the whole process again. That is all nice and good. > > However, why is it, that the talairach volume is always, no matter which > subject I look at, is always significantly smaller than the target volume? Is > that normal? Has it to be fixed? Or is that just normal? Attached find one > example. > As I am using freesurfer for the first time, I am really unsure about that. > > Thanks for the help, > Maria > > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
