Hi Natalia, check your qdec/.QDECRC file, it needs to contain:
MEASURE1 = long.thickness-avg MEASURE2 = long.thickness-rate MEASURE3 = long.thickness-pc1 MEASURE4 = long.thickness-spc probably you put a .spc instead of -spc Best, Martin On Fri, 2011-07-22 at 18:51 +0200, Natalia h wrote: > Dear list, > > I got an error after following the newer version of the longitudinal > stream 5.1. > > long_mris_slopes worked without problems for my data which was > longtudinally processed in 4.5. > > I also split the qdec.table to the cross for being able to be loaded > in qdec GUI. > > Somehow I got the error that the > Templatesubxx/surf/xh.thickness.fwhm.xx.fsaverage.mgh. > > I went back to check inside the Templatesubxx/surf has only the > xh.long.thickness-xxx.fwhmx.fsaverage.mgh > > Is there something I am missing? > > Thanks a lot for the help > _______________________________________________ > Freesurfer mailing list > Freesurfer@nmr.mgh.harvard.edu > https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer > > _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
