Hi, Freesurfers. Last time I used Freesurfer v4.5 first, manually corrected the data, then ran the rest steps in Freesurfer v5.0. As Bruce suggested, I should rerun the data. Actually the visual check and manual correction steps have taken me one month as we have hundreds of data, so I really hope to use the previous edits. If I hope to get the v5.0 outputs, can I rerun the data with previously corrected edits? In another word, if I previously sub001 was only editted on its pial surface.In this rerun process, can I run the first stages including pial surface generation (stages 1-21), then replaced with the previously edited pial surface, then run the rest stages(21-31)? Is this acceptable, or is there any other ways to rerun the data and can take use of previous edits? Thank you very much for all your suggestions. Jin
_______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
