Hi Ri, You can try using the dilate and erode label tool in tksurfer. Click on subject Y's label and in the tksurfer tools window,
Tools -> Labels -> Dilate Selected Label Tools -> Labels -> Erode Selected Label Sita. On Sun, 10 Oct 2010, Ritobrato Datta wrote: > Hello All, > > I hand drew a label on subject X's inflated surface using the tools in > tksurfer outlined in > http://surfer.nmr.mgh.harvard.edu/fswiki/TkSurferGuide/TkSurferWorkingWithData/TkSurferLabel, > > then I applied the label to Subject Y using mrilabel2label specifically - > > mri_label2label --srclabel ROI-subjX.label --srcsubject SubjX --trglabel > ROI-subjY.label --trgsubject SubjY --regmethod surface --hemi lh > > The problem is on surface of subject Y, when I upload the label, I see these > holes inside the label (please see figure attached). > > Can anyone tell how do I get rid of them ? > > Thanks much > > Ri _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer The information in this e-mail is intended only for the person to whom it is addressed. If you believe this e-mail was sent to you in error and the e-mail contains patient information, please contact the Partners Compliance HelpLine at http://www.partners.org/complianceline . If the e-mail was sent to you in error but does not contain patient information, please contact the sender and properly dispose of the e-mail.
