Hello, We have some white matter surfaces created using non-FS software in which we have subsequently "cut-out" via hand contouring specific gyri and sulci of interest (e.g., cingulate). I would like to be able to use these extracted surfaces to create a label file in FS corresponding to the matching surface region within FS. Is there a way to accomplish this using existing Freesurfer binary or matlab functions?
More specifically, we can define these extracted surfaces in the native scan space, and get them into a vtk format (which should be readable by mris_convert). Do you have any suggestions for the easiest way to then "translate" the region defined by this surface into a corresponding region on the FS white matter surface? Ideally, since our in-house surface defines an enclosed set of vertices, the ensuing label file in FS would represent an enclosed set of vertices as well. thanks for your suggestions, Mike H. -- Michael Harms, Ph.D. -------------------------------------------------------------------- Conte Center for the Neuroscience of Mental Disorders Washington University School of Medicine Department of Psychiatry, Box 8134 Renard Hospital, Room 6615 Tel: 314-747-6173 660 South Euclid Ave. Fax: 314-747-2182 St. Louis, MO 63110 Email: [EMAIL PROTECTED] -------------------------------------------------------------------- _______________________________________________ Freesurfer mailing list Freesurfer@nmr.mgh.harvard.edu https://mail.nmr.mgh.harvard.edu/mailman/listinfo/freesurfer
