Hi, If I type the following command into mode: MODE COM1:BAUD=9600 DATA=8 STOP=1 PARITY=N DTR=OFF RTS=OFF
and then go: MODE COM1 BAUDHARD=1 I get: UART is 16450 or newer. Reading parameters: no parity, 1 stop bit, 8 bit, 9600 baud, RTS on, DTR on. For the life of me I can't figure out how to turn RTS and DTR off. Am I doing something wrong? I don't get any error in the mode command when I type DTR=OFF or RTS=OFF. I suspect that DTR/RTS being on is the reason why I cannot write to the serial port. Thanks
_______________________________________________ Freedos-user mailing list Freedos-user@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/freedos-user
