on 25/02/2008 15:02 Andriy Gapon said the following: > on 04/02/2008 05:52 Pyun YongHyeon said the following: >> On Fri, Feb 01, 2008 at 03:56:17PM +0200, Andriy Gapon wrote: >> > on 01/02/2008 15:42 Andriy Gapon said the following: >> > > on 01/02/2008 14:36 Pyun YongHyeon said the following: >> > >> After applying attached patch and let me know the output of >> > >> "devid : xxx, revid : xxx, pwr = xxx". It would be even better >> > >> if you can show me the above message for working/non-working case. >> > >> >> > >> >> > > >> > > Applied the patch with correction to actually print rev instead of dev >> > > for the second time :-) >> > > This is in working case: >> > > devid : 269, revid : a3, pwr = 00000003 >> > >> > A clarification: I just applied the patch, recompiled and re-loaded the >> > module. There was no reboot/poweroff/reset in between. >> > >> > > Will wait for the non-working situation. >> > > >> > >> >> Revert previous patch and try attached patch again and let me know >> how it goes. >> >> > > Tried it - still no joy, the behavior is as before. > If I gracefully reboot the machine or power down and then up, then > everything is OK. But if I press "reset" button and boot up, the nfe > interface is "dead". > BTW, I kept the line for printing devid/revid/pwr and output is the same > in all cases. >
Not sure if that is related but Linux forcedeth driver seems to do some stuff that we don't do: http://lxr.linux.no/linux+v2.6.24/drivers/net/forcedeth.c#L5271 -- Andriy Gapon _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
