Artyom Viklenko <[EMAIL PROTECTED]> wrote: >> >> I have just installed FreeBSD/i386 6.1-RC2 on a AMD Athlon 64 X2 3800+, >> Asus A8N-SLI Deluxe Motherboard and 2 GB RAM. The Motherboard has two >> Ethernet-Ports for 1000BaseT which dmesg gives out as: >> skc0: <Marvell Gigabit Ethernet> port 0xa400-0xa4ff mem 0xd1004000- >> 0xd1007fff irq 17 at device 12.0 on pci5 >> skc0: Marvell Yukon Lite Gigabit Ethernet rev. (0x9) >> sk0: Ethernet address: 00:11:d8:ca:ed:43 >> nve0: Ethernet address 00:11:d8:ca:e1:8b >> >> I read about problems with the nve driver, so I only configured the skc0 >> device. It is connected to a 100MBit Hub, and all other computers in my
Sorry, it's a switch, of course. >> What might be the reason for my problems? Is there a problem in the >> support for my skc0 device? What could I do to solve my problems? > > I my case ther was bad memory in target system. Try to check/replace > RAM in AMD machine. I will try running memtest86. But by browsing through this list I found the thread "sk0: watchdog timeout" and the problem described there is quite similiar to what I get here. So perhaps this bug in the sk driver is also the cause for my trouble here?! Can I somehow use this patch for sk0 _without_ changing everything to -current? Acutually, I wanted to stay to 6.1-RELEASE... Michael _______________________________________________ freebsd-stable@freebsd.org mailing list http://lists.freebsd.org/mailman/listinfo/freebsd-stable To unsubscribe, send any mail to "[EMAIL PROTECTED]"
