Michael Gerhards wrote:
> Hello!
>
> I have just installed FreeBSD/i386 6.1-RC2 on a AMD Athlon 64 X2 3800+,
> Asus A8N-SLI Deluxe Motherboard and 2 GB RAM. The Motherboard has two
> Ethernet-Ports for 1000BaseT which dmesg gives out as:
> skc0: <Marvell Gigabit Ethernet> port 0xa400-0xa4ff mem 0xd1004000-
> 0xd1007fff irq 17 at device 12.0 on pci5
> skc0: Marvell Yukon Lite Gigabit Ethernet rev. (0x9)
> sk0: Ethernet address: 00:11:d8:ca:ed:43
> nve0: Ethernet address 00:11:d8:ca:e1:8b
>
> I read about problems with the nve driver, so I only configured the skc0
> device. It is connected to a 100MBit Hub, and all other computers in my
> local networks have 100MBit card, too.
>
> I tried to copy some larger files to the new system via scp from my old
> Pentium2-300, running FreeBSD/i386 6.1-RC1. But scp ends this copying
> at some (not predictable) place with either
> "Received disconnect from 192.168.1.9: 2: Corrupted MAC on input.
> lost connection"
> or
> "Write failed: Connection reset by peer
> lost connection"
> (I ran scp on the old Pentium2 system).
>
> Copying between my Pentium2 and the other computers in my local network
> (all running at 100MBit full duplex mode) is without any problems.
>
> What might be the reason for my problems? Is there a problem in the
> support for my skc0 device? What could I do to solve my problems?
I my case ther was bad memory in target system. Try to check/replace
RAM in AMD machine.
--
Sincerely yours,
Artyom Viklenko.
-------------------------------------------------------
[EMAIL PROTECTED] | http://www.aws-net.org.ua/~artem
FreeBSD: The Power to Serve - http://www.freebsd.org
_______________________________________________
freebsd-stable@freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-stable
To unsubscribe, send any mail to "[EMAIL PROTECTED]"
